Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM3090E _51 Engine / Hybrid System _008396 2AR-FE ENGINE MECHANICAL _0046876 REAR CRANKSHAFT OIL SEAL A

2AR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 30300 2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 30500 3.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Hide 31210 5.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250 6.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 13405 7.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

a.
A195875E01
0.384,1.203 0.714,1.359 0.33,0.156 10 SST 0.779,1.272 0.934,1.272 0.934,1.272 1.322,1.143 false 1.238,0.738 0.934,1.272 false

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

Part number of installation bolt for SST (crankshaft pulley holdingtool): 91551-80650 (quantity: 2)



b.
A238739

Remove the 8 bolts and flywheel.


Hide 32101 8.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

a.
A195875E01
0.384,1.203 0.714,1.359 0.33,0.156 10 SST 0.779,1.272 0.934,1.272 0.934,1.272 1.322,1.143 false 1.238,0.738 0.934,1.272 false

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

Part number of installation bolt for SST (crankshaft pulley holdingtool): 91551-80650 (quantity: 2)



b.
A238740

Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.


Hide 11401L 9.REMOVE REAR ENGINE OIL SEAL

a.
A293109C03
2.813,1.646 2.813,1.521 2.813,1.521 3.083,1.01 false 2.188,1.979 2.042,1.979 2.042,1.979 1.156,1.5 true 2.74,1.667 3.052,1.823 0.313,0.156 10 false *1 2.24,1.885 2.417,2.042 0.177,0.156 10 false *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole or the crankshaft.


HINT:

Tape the screwdriver tip before use.