Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMBUSTION TYPE POWER HEATER SYSTEM › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049438 COMBUSTION TYPE POWER HEATER SYSTEM C

HEATING / AIR CONDITIONING  COMBUSTION TYPE POWER HEATER SYSTEM  015  Operating Block caused by Overheating  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
015 Operating Block caused by Overheating The control overheating sensor detects overheating of the engine coolant, and the power heater ECU stops the operation of the heater assembly. (DTCs 012 and/or 014 are detected 10 times in a row.)
·

Engine coolant circuit (leaks, engine coolant quality, thermostat, water pump assembly)

·

Heater assembly



CAUTION / NOTICE / HINT

HINT:

Clear the DTCs by pressing the memory clear buttons on the tester to unlock the ECU.


PROCEDURE

1.CHECK FOR ENGINE COOLANT LEAKS
a.

Result:
Proceed to
OK
NG



OK

2.CHECK ENGINE COOLANT QUALITY

NG

2.CHECK ENGINE COOLANT QUALITY

OK

3.INSPECT THERMOSTAT

NG

REPLACE ENGINE COOLANT

3.INSPECT THERMOSTAT
a.

Remove the thermostat.

for 1AD-FTV:

Click here

Click hereEngine / Hybrid System>1AD-FTV COOLING>THERMOSTAT>REMOVAL

for 2AD-FHV:

Click hereEngine / Hybrid System>2AD-FHV COOLING>THERMOSTAT>REMOVAL

for 2AD-CCo, 2AD-DPF:

Click hereEngine / Hybrid System>2AD-FTV COOLING>THERMOSTAT>REMOVAL


b.

Result:
Proceed to
OK
NG



OK

4.INSPECT WATER PUMP ASSEMBLY

NG

4.INSPECT WATER PUMP ASSEMBLY
a.

Remove the water pump assembly.

for 1AD-FTV:

Click hereEngine / Hybrid System>1AD-FTV COOLING>WATER PUMP>REMOVAL

for 2AD-FHV:

Click hereEngine / Hybrid System>2AD-FHV COOLING>WATER PUMP>REMOVAL

for 2AD-CCo, 2AD-DPF:

Click hereEngine / Hybrid System>2AD-FTV COOLING>WATER PUMP>REMOVAL



Result:
Proceed to
OK
NG



OK

NG