1.INSTALL BRAKE ACTUATOR WITH BRACKET
When installing a new brake actuator, do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
Install the actuator with bracket with the 3 nuts.
Tighten the 3 nuts uniformly in alphabetical order.
Be careful not to damage the brake tubes.
Do not drop the actuator. If dropped, replace it.
Connect the brake tube clamp to the bracket.
2.CONNECT BRAKE LINES
Temporarily install each brake line to the correct positions of the actuator assembly with bracket as shown in the illustration.
*1: to front wheel cylinder RH
*2: to front wheel cylinder LH
*3: to rear wheel cylinder RH
*4: to rear wheel cylinder LH
*5: from front master cylinder
*6: from rear master cylinder
Using a union nut wrench, tighten each brake line.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.CONNECT CONNECTOR
Make sure that the connector is locked securely.
Make sure that the actuator connector can be connected smoothly. Do not allow water, oil or dirt to enter.
Connect the brake actuator connector and push the lock lever downward.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.BLEED BRAKE SYSTEM
6.BLEED CLUTCH LINE (for Manual Transaxle)
for 1AD-FTV:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 1AD-FTV)>BLEEDING
for 2AD-FTV:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AD-FTV)>BLEEDING
for 2AR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AR-FE)>BLEEDING
for 3ZR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FE)>BLEEDING
for 3ZR-FAE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FAE)>BLEEDING
7.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
for 1AD-FTV:
Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECM>INSTALLATION
for 2AD-FHV:
Click hereEngine / Hybrid System>2AD-FHV ENGINE CONTROL>ECM>INSTALLATION
for 2AD-FTV:
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECM>INSTALLATION
for 2AR-FE:
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>INSTALLATION
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE ENGINE CONTROL>ECM>INSTALLATION
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>ECM>INSTALLATION
44510
8.INSPECT BRAKE ACTUATOR WITH GTS