1.DRAIN TRANSFER OIL
43410
2.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
17118
3.REMOVE MANIFOLD STAY (for 3ZR-FE, 3ZR-FAE)
43457
4.REMOVE DRIVE SHAFT BEARING BRACKET
for 2AD-FTV, 2AD-FHV: (Click hereEngine / Hybrid System>2AD-FHV ENGINE MECHANICAL>ENGINE UNIT>REMOVAL)
for 2AR-FE: (Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL)
for 3ZR-FE, 3ZR-FAE: (Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL)
36113A
5.REMOVE TRANSFER CASE OIL SEAL RH
| *1 | Transfer Case Oil Seal RH |
Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.
Do not scratch the press-fitting surface of the transfer case oil seal RH.
36113A
6.INSTALL TRANSFER CASE OIL SEAL RH
| *1 | Transfer Case Oil Seal RH |
Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.
7.5 to 8.5 mm (0.296 to 0.334 in.)
Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
Do not tap the transfer case oil seal RH in too far.
43457
7.INSTALL DRIVE SHAFT BEARING BRACKET
for 2AD-FTV, 2AD-FHV: (Click hereEngine / Hybrid System>2AD-FHV ENGINE MECHANICAL>ENGINE UNIT>INSTALLATION)
for 2AR-FE: (Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION)
for 3ZR-FE, 3ZR-FAE: (Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION)
17118
8.INSTALL MANIFOLD STAY (for 3ZR-FE, 3ZR-FAE)
43410
9.INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
10.ADD TRANSFER OIL
11.INSPECT TRANSFER OIL LEAK