Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008784 METER / GAUGE / DISPLAY _0050254 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Fuel Receiver Gauge Malfunction  


DESCRIPTION

The fuel sender gauge assembly has a variable resistance mechanism. The resistance decreases when the fuel amount increases, and the resistance increases when the fuel amount decreases. The fuel receiver gauge changes based on the resistance of the fuel sender gauge assembly.


WIRING DIAGRAM

E270440E01
4.313,4.177 6.385,4.521 2.073,0.344 10 Combination Meter Assembly 4.292,3.979 4.74,4.208 0.448,0.229 10 G16 5.083,1.875 5.531,2.104 0.448,0.229 10 CPU 5.531,1.385 5.979,1.615 0.448,0.229 10 FUEL 4.583,1.063 5.031,1.292 0.448,0.229 10 I/F 1.677,2.125 2.125,2.354 0.448,0.229 10 V2 1.688,2.313 3.667,2.573 1.979,0.26 10 Fuel Sender Gauge Assembly 1.896,1.573 2.052,1.76 0.156,0.188 10 1 3.063,1.563 3.271,1.729 0.208,0.167 10 2 4,1 4.271,1.167 0.271,0.167 10 16 4.01,1.573 4.281,1.74 0.271,0.167 10 15 4.281,1 4.531,1.219 0.25,0.219 10 L 4.292,1.677 4.542,1.896 0.25,0.219 10 E

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (FUEL METER OPERATION)
a.

Using the GTS, perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F -
Body Electrical > Combination Meter > Active Test
Tester Display
Fuel Meter Operation
50004 122 3
OK:

Fuel receiver gauge indication is normal.



Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS (FUEL INPUT)

NG

REPLACE COMBINATION METER ASSEMBLY

2.READ VALUE USING GTS (FUEL INPUT)
a.

Using the GTS, read the Data List.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Fuel Input Fuel input signal Min.: 0 L, Max.: 127.5 L Current fuel level displayed -
Body Electrical > Combination Meter > Data List
Tester Display
Fuel Input
50003 122 39

Result:
Result Proceed to
Fuel level data displayed on the GTS is almost the same as the fuel receiver gauge indication. A
Fuel level data displayed on the GTS differs from the fuel receiver gauge indication. B



A

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY)

B

REPLACE COMBINATION METER ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY)
a.

Disconnect the G16 combination meter assembly connector.


b.

Disconnect the V2 fuel sender gauge assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G16-16 (L) - V2-1 Always Below 1 Ω
G16-15 (E) - V2-2
G16-16 (L) or V2-1 - Body ground Always 10 kΩ or higher
G16-15 (E) or V2-2 - Body ground



Result:
Proceed to
OK
NG



OK

4.INSPECT FUEL SENDER GAUGE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT FUEL SENDER GAUGE ASSEMBLY

OK

REPLACE COMBINATION METER ASSEMBLY

NG (1AD-FTV)

REPLACE FUEL SENDER GAUGE ASSEMBLY

NG (2AD-FHV)

REPLACE FUEL SENDER GAUGE ASSEMBLY

NG (2AD-FTV)

REPLACE FUEL SENDER GAUGE ASSEMBLY

NG (2AR-FE)

REPLACE FUEL SENDER GAUGE ASSEMBLY

NG (3ZR-FAE)

REPLACE FUEL SENDER GAUGE ASSEMBLY

NG (3ZR-FE)

REPLACE FUEL SENDER GAUGE ASSEMBLY