When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
for 3ZR-FE:
Click hereEngine / Hybrid System>3ZR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL
28100
2.REMOVE STARTER ASSEMBLY
for 3ZR-FAE:
Click hereEngine / Hybrid System>3ZR-FAE STARTING>STARTER>REMOVAL
for 3ZR-FE for 1.0 kW Type:
Click hereEngine / Hybrid System>3ZR-FE STARTING>STARTER(for 1.0 kW Type)>REMOVAL
for 3ZR-FE for 1.3 kW Type:
Click hereEngine / Hybrid System>3ZR-FE STARTING>STARTER(for 1.3 kW Type)>REMOVAL
30300
3.REMOVE MANUAL TRANSAXLE ASSEMBLY
Remove the bolt and clamp.
Disconnect the back-up light switch connector and remove the bolt and engine wire from the manual transaxle assembly.
Remove the 8 bolts and manual transaxle assembly.
12311A
4.REMOVE FRONT ENGINE MOUNTING BRACKET
Remove the 4 bolts and front engine mounting bracket.
12325A
5.REMOVE ENGINE MOUNTING BRACKET LH
Remove the 4 bolts and engine mounting bracket LH.
12321A
6.REMOVE REAR ENGINE MOUNTING BRACKET
Remove the 4 bolts and rear engine mounting bracket.
31490
7.REMOVE CLUTCH ACCUMULATOR ASSEMBLY
31407B
8.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY
31400
9.REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY
33403K
10.REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY
Remove the bolt and speedometer driven hole cover sub-assembly from the manual transaxle case.
Remove the O-ring from the speedometer driven hole cover sub-assembly.
36100
11.REMOVE TRANSFER ASSEMBLY
36100A
12.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
Transfer Side:
Click hereDrivetrain>GF1A TRANSFER / 4WD / AWD>TRANSFER ASSEMBLY>DISASSEMBLY
Remove the 2 transfer and transaxle setting stud bolts.
It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.