Home › Engine / Hybrid System › 3ZR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2015.04
RM3090E _51 Engine / Hybrid System _008405 3ZR-FE ENGINE MECHANICAL _0046948 REAR CRANKSHAFT OIL SEAL A

3ZR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 30300 1.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 30400 2.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)

Hide 31210 3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31250 4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 13405 5.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

a.
A234914N08
1.396,1.938 1.948,0.615 1.948,0.615 2.313,0.615 true 1.781,2.042 1.948,0.615 true 2.344,0.521 2.646,0.688 0.302,0.167 10 SST

Using SST, hold the crankshaft.

SST
09213-54015  09330-00021  

HINT:

Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-00850 (quantity: 2).



b.
A200718

Remove the 8 bolts and flywheel sub-assembly.


Hide 32101 6.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)

a.
A234914N08
1.396,1.938 1.948,0.615 1.948,0.615 2.313,0.615 true 1.781,2.042 1.948,0.615 true 2.344,0.521 2.646,0.688 0.302,0.167 10 SST

Using SST, hold the crankshaft.

SST
09213-54015  09330-00021  

HINT:

Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-00850 (quantity: 2).



b.
A200719

Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.


Hide 11401L 7.REMOVE ENGINE REAR OIL SEAL

a.
A154925C08
0.823,1.375 0.885,1.771 0.885,1.771 0.948,1.771 false 2.063,1.333 2.844,0.854 2.844,0.854 2.979,0.854 true 0.99,1.688 1.177,1.875 0.188,0.188 10 *1 3.021,0.781 3.208,0.969 0.188,0.188 10 *2
*1 Cut Position
*2 Protective Tape


Using a knife, cut off the lip of the engine rear oil seal.


b.

Using a screwdriver with its tip wrapped with tape, pry out the engine rear oil seal.

NOTICE:
·

Do not damage the surface of the oil seal press fit hole or the crankshaft.

·

After removing the engine rear oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.