11302A
1.INSTALL TIMING CHAIN COVER OIL SEAL
Apply MP grease to the lip of a new timing chain cover oil seal.
Do not allow foreign matter to contact the lip of the timing chain cover oil seal.
Do not allow MP grease to contact the timing chain cover oil seal.
Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.
Wipe off any extra grease from the crankshaft.
Do not tap in the timing chain cover oil seal at an angle.
13471
2.INSTALL CRANKSHAFT PULLEY
| *a | Hold |
|
Turn |
Align the key groove of the crankshaft pulley with the pulley set key.
Temporarily install the crankshaft pulley with the pulley bolt.
Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.
The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).
16361A
3.INSTALL V-RIBBED BELT
16361A
4.INSPECT V-RIBBED BELT
51217A
5.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
6.ADD ENGINE OIL
7.INSPECT FOR OIL LEAK
51443
8.INSTALL REAR ENGINE UNDER COVER RH
51441
9.INSTALL NO. 1 ENGINE UNDER COVER
11212
10.INSTALL NO. 2 CYLINDER HEAD COVER