Home › Power Source / Network › 2WW BATTERY / CHARGING › GENERATOR › from 2015.10
RM3090E _57 Power Source / Network _044381 2WW BATTERY / CHARGING _0212676 GENERATOR A

2WW BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized afterthe cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE REAR ENGINE UNDER COVER RH

Hide 5.REMOVE FAN AND GENERATOR V BELT

Hide 27020 6.REMOVE GENERATOR ASSEMBLY

a.
A370607

Disconnect the generator connector.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the generator wire.


d.
A370608N01
1.083,1.979 1.24,2.177 0.156,0.198 10 true A

Using an E12 "TORX" socket wrench, remove the 2 bolts as shown in the illustration.

HINT:

Bolt A cannot be removed with the generator assembly installed to the vehicle.



e.
A370609

Remove the genrator assembly as shown in the illustration.