Home › Engine / Hybrid System › 2WW STARTING › STARTER › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219541 STARTER A

2WW STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Using an E14 "TORX" socket wrench, install the starter assembly with the 2 bolts.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


b.

Connect the engine wire to the starter assembly with the nut.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.

Connect the No. 2 engine wire to the starter assembly with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Close the terminal cap.


Hide 11409 2.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Apply a light coat of engine oil to a new O-ring.


b.

Install the O-ring to the engine oil level dipstick guide.


c.

Using a T25 "TORX" socket wrench, install the engine oil level dipstick guide with the bolt.


d.

Engage the clamp and connect the fuel feed pipe sub-assembly to the engine oil level dipstick guide.


e.

Install the engine oil level dipstick.


f.

Engage the 6 clamps and connect the No. 2 engine wire to the engine oil level dipstick guide.


Hide 25733A 3.CONNECT NO. 1 VACUUM PIPE

a.

Apply a light coat of engine oil to a new O-ring.


b.

Install the O-ring to the No. 1 vacuum pipe.


c.

Using an E7 "TORX" socket wrench, connect the No. 1 vacuum pipe to the cylinder block sub-assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 74431 6.INSTALL BATTERY TRAY

Hide 28800 7.INSTALL BATTERY

Hide 28899 8.INSTALL BATTERY INSULATOR

Hide 10.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

Hide 51441 11.INSTALL NO. 1 ENGINE UNDER COVER

Hide 12612A 12.INSTALL NO. 1 ENGINE COVER

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION