44696
1.INSTALL VACUUM SENSOR GROMMET (w/ Stop And Start System)
Install the vacuum sensor grommet to the brake booster.
89420H
2.INSTALL VACUUM SENSOR ASSEMBLY (w/ Stop And Start System)
Install the vacuum sensor to the vacuum sensor grommet.
44696
3.INSTALL CHECK VALVE GROMMET
Install a new check valve grommet to the brake booster.
44730
4.INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY
Install the brake vacuum check valve to the check valve grommet.
44785
5.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster.
47264D
6.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Install the push rod clevis to the brake booster.
44610
7.INSTALL BRAKE BOOSTER ASSEMBLY
Install the brake booster with the 4 nuts.
Do not damage the brake tubes.
47264A
8.INSTALL PUSH ROD PIN
47101A
9.INSTALL BRAKE PEDAL RETURN SPRING
10.CHECK AND ADJUST BRAKE BOOSTER PUSH ROD
11.CONNECT VACUUM HOSE
Connect the vacuum hose with the clip.
47201
12.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
73900
13.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
55432B
14.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)
55735C
15.INSTALL COWL BODY MOUNTING REINFORCEMENT RH
Install the cowl body mounting reinforcement RH with the 2 nuts.
55701J
16.INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
Install the cowl top panel outer sub-assembly with the 13 bolts.
55081E
17.INSTALL COWL VENTILATOR HOUSING SUB-ASSEMBLY
Engage the 3 clips to install the cowl ventilator housing sub-assembly.
85160
18.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
20.BLEED BRAKE SYSTEM
21.BLEED CLUTCH LINE (for Manual Transaxle)
for 2AD-FTV:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AD-FTV)>BLEEDING
2AR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AR-FE)>BLEEDING
for 3ZR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FE)>BLEEDING
for 3ZR-FAE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FAE)>BLEEDING
for 2WW:
22.CHECK AND ADJUST BRAKE PEDAL