Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45510
1.INSTALL STEERING GEAR ASSEMBLY
Install the steering gear assembly to the front suspension crossmember with the 2 bolts and 2 nuts.
Make sure to tighten the bolts starting from the left side of the vehicle.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut fixed in place.
45221
2.INSTALL STEERING INTERMEDIATE SHAFT
| *a | Matchmark |
Align the matchmarks and install the steering intermediate shaft to the steering gear assembly.
Install the bolt.
45025D
3.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Align the round hole in the No. 1 steering column hole cover assembly with the protrusion of the steering gear assembly and install the cover.
Install a new clamp.
51201
4.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
45319A
5.INSTALL STEERING GEAR HEAT INSULATOR (for ZR Series Engine RHD)
Install the heat insulator and bolt to the steering gear.
52258B
6.INSTALL FRONT SUSPENSION MEMBER REAR BRACE LH
52257A
7.INSTALL FRONT SUSPENSION MEMBER REAR BRACE RH
Use the same procedure described for the LH side.
51425B
8.INSTALL LOWER ENGINE FRONT MOUNTING BRACKET REINFORCEMENT (for 3ZR-FE (2WD) and 1AD-FTV)
51218A
9.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH
51217A
10.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
Use the same procedure described for the LH side.
48810
11.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B
12.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
45047
13.CONNECT TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end to the steering knuckle with the nut.
Tighten the nut up to an additional 60° if the holes for the cotter pin are not aligned.
Install a new cotter pin.
45046
14.CONNECT TIE ROD END SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
45260
15.CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
Align the matchmarks and install the No. 2 steering intermediate shaft assembly to the intermediate shaft.
Install the bolt.
45259A
16.INSTALL COLUMN HOLE COVER SILENCER SHEET
51444
17.INSTALL REAR ENGINE UNDER COVER LH
51443
18.INSTALL REAR ENGINE UNDER COVER RH
50819
19.INSTALL FRONT FLOOR COVER
51441
20.INSTALL NO. 1 ENGINE UNDER COVER
for 2AD Engine: Click hereEngine / Hybrid System>2AD-FHV ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
for 2AR-FE and 3ZR-FE: Click hereEngine / Hybrid System>2AR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
for 3ZR-FAE Engine: Click hereEngine / Hybrid System>3ZR-FAE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
for 2WW: Click hereEngine / Hybrid System>2WW ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION
21.INSTALL FRONT WHEELS
22.POSITION FRONT WHEELS FACING STRAIGHT AHEAD
23.ADJUST FRONT WHEEL ALIGNMENT