Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43340A
1.INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH
Secure the front axle assembly between aluminum plates in a vise.
When using a vise, do not overtighten it.
Install the front lower ball joint to the front axle assembly with the nut.
Install a new cotter pin.
If the holes for the cotter pin are not aligned, align the holes by tightening the nut as necessary up to an additional 60°.
2.INSTALL FRONT AXLE ASSEMBLY LH
48069
3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
45047
4.CONNECT TIE ROD END SUB-ASSEMBLY LH
43512
5.INSTALL FRONT DISC
6.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
47313A
7.CONNECT FRONT FLEXIBLE HOSE
8.CONNECT FRONT SPEED SENSOR LH
43502H
9.INSTALL FRONT AXLE SHAFT NUT LH
10.INSTALL FRONT WHEEL
11.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
12.CHECK SPEED SENSOR SIGNAL