Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for RHD) › 2018.10–2020.08
RM3620E _52 Drivetrain _076045 CLUTCH _0370084 CLUTCH MASTER CYLINDER(for RHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch master cylinder removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system for M20A-FKS:(Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


CAUTION:
·
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE KNEE AIRBAG ASSEMBLY (for Driver Side)

Hide 4.DRAIN CLUTCH FLUID

NOTICE:

Wash brake fluid off immediately if it adheres to any painted surface.


Hide 31434E 5.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE

C403564

a.

Slide the hose clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31481 6.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C403565

a.

Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.

HINT:

Use a container to collect the fluid.



Hide 31453A 7.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN

Hide 31410 8.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C403566

Remove the 2 nuts and clutch master cylinder assembly from the vehicle body.


Hide 31415 9.REMOVE CLUTCH MASTER CYLINDER GASKET

C408264

a.

Remove the clutch master cylinder gasket from the clutch master cylinder assembly.