The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch pedal stroke sensor assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/o Occupant Classification System)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for M20A-FKS:General>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE KNEE AIRBAG ASSEMBLY (for Driver Side)
4.DISCONNECT WIRE HARNESS CONNECTOR
Disconnect the wire harness connector from the clutch pedal stroke sensor.
89280
5.REMOVE CLUTCH PEDAL STROKE SENSOR ASSEMBLY
Remove the 2 nuts and clutch pedal stroke sensor from the clutch pedal support assembly.
Do not drop the clutch pedal stroke sensor.
If the clutch pedal stroke sensor has been dropped, replace the clutch pedal stroke sensor with a new one.