CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
| *A | except LHD, Manual Transaxle | *B | for LHD, Manual Transaxle |
| *1 | Main body ECU (multiplex network body ECU) | - | - |
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
Reconnect the instrument panel junction block assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Input/Output | Terminal Description | Condition | Specified Condition | Related Data List Item |
|---|---|---|---|---|---|---|
| A-11 (GND1) - Body ground | - | - | Ground | Always | Below 1 Ω | - |
| A-30 (ACC) - Body ground | - | Input | ACC power supply | Ignition switch ACC | 11 to 14 V | ACC SW |
| Ignition switch off | Below 1 V | |||||
| A-31 (BECU) - Body ground | - | Input | Battery power supply | Always | 11 to 14 V | - |
| A-32 (IG) - Body ground | - | Input | IG power supply | Ignition switch ON | 11 to 14 V*1
10.5 to 16 V*2 |
IG SW |
| Ignition switch off | Below 1 V |
*1: except Manual Transaxle, with Stop and Start System
*2: for Manual Transaxle, with Stop and Start System
Install the main body ECU (multiplex network body ECU) to instrument panel junction block assembly.
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>INSTALLATION
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>INSTALLATION
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Input/Output | Terminal Description | Condition | Specified Condition | Related Data List Item |
|---|---|---|---|---|---|---|
| G45-11 (PRG) - Body ground | B - Body ground | Output | Output to door control receiver | Key inserted into ignition key cylinder → Key pulled out of ignition key cylinder | 11 to 14 V → Pulse generation → 11 to 14 V | - |
| G45-10 (RDA) - Body ground | R - Body ground | Input | Input from door control receiver | Procedure:
1.
Remove key from ignition key cylinder 2.
Close all doors 3.
Press lock or unlock switch of door control transmitter module set sub-assembly |
11 to 14 V → Pulse generation | - |