Home › Engine / Hybrid System › CRUISE CONTROL › LANE CONTROL SYSTEM
RM3620E _51 Engine / Hybrid System _076038 CRUISE CONTROL _0370841 LANE CONTROL SYSTEM T

CRUISE CONTROL  LANE CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

If no problem symptoms are found when a DTC is output in the DTC check on the lane control system, check each symptom by checking the suspected areas in the order they are listed.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



HINT:

Before performing failure diagnosis according to the following inspection points, check the forward recognition camera system power source circuit fuses and relays.


LANE CONTROL SYSTEM
Symptom Suspected Area Link
Lane control system does not operate at all Steering pad switch circuit Click here
Forward recognition camera adjustment
HINT:

Perform forward recognition camera axis alignment with either "One time recognition" or "Sequential recognition".


·

One time recognition:Click here

·

Sequential recognition:Click here


The LTA/LDA indicator light does not turn on even by operating the LTA/LDA main switch (steering pad switch assembly) Indicator circuit Click here
Steering pad switch circuit Click here
Combination meter assembly Click here
The LTA/LDA indicator light does not turn off even by operating the LTA/LDA main switch (steering pad switch assembly) Indicator circuit Click here
Steering pad switch circuit Click here
Combination meter assembly Click here
The lane control system is not canceled even by operating the turn signals Data list / Active test (Check the item "Turn Switch (Right)", "Turn Switch (Left)") Click here
Turn signal switch circuit Click here
The lane control system does not operate many times even when the white lines are visible Check conditions for operating/not operating Click here
Forward recognition camera adjustment
HINT:

Perform forward recognition camera axis alignment with either "One time recognition" or "Sequential recognition".


·

One time recognition:Click here

·

Sequential recognition:Click here


The lane control system is operating but the system control status is not displayed on the multi-information display Data list / Active test (Check the item "LDA Control") Click here
Combination meter assembly Click here
Lane departure warning function is on but the buzzer does not sound even when straying from white line Combination meter assembly Click here