A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
86790B
1.INSTALL FRONT TELEVISION CAMERA ASSEMBLY
| *A | except Off Road Pacakge |
| *B | for Off Road Pacakge |
Attach the guide and install the front television camera assembly.
Install the 2 screws.
Tighten the screws in the order shown in the illustration.
| *A | except Off Road Pacakge |
| *B | for Off Road Pacakge |
Connect the connector.
2.INSTALL FRONT BUMPER ASSEMBLY (w/ NO. 1 RADIATOR TO SUPPORT SEAL)
except Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>INSTALLATION
for Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Off Road Package)>INSTALLATION
16681A
3.INSTALL RADIATOR UPPER AIR GUIDE PLATE (w/o NO. 1 RADIATOR TO SUPPORT SEAL)
|
Place Hands Here |
|
Pull in this Direction |
Place both hands at the position shown in the illustration and pull in the direction.
|
Install in this Direction |
Install the radiator upper air guide plate as shown in the illustration.
|
Bolt |
|
Clip |
Install the 4 bolts.
Install the 5 clips.
53510
4.INSTALL HOOD LOCK ASSEMBLY (w/o NO. 1 RADIATOR TO SUPPORT SEAL)
17750A
5.INSTALL INLET AIR CLEANER ASSEMBLY (for Gasoline Model, w/o NO. 1 RADIATOR TO SUPPORT SEAL)
for A25A-FKS:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION
for M20A-FKS:
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>THROTTLE BODY>INSTALLATION
86790B
6.ADJUST FRONT TELEVISION CAMERA ASSEMBLY
for Gasoline Model:
53301
7.INSPECT FITTING OF HOOD SUB-ASSEMBLY
8.PERFORM CALIBRATION (w/ NO. 1 RADIATOR TO SUPPORT SEAL)
w/ Parking Support Brake System (for HV Model):
w/ Parking Support Brake System (for Gasoline Model):