Home › Vehicle Exterior › HORN › HORN › 2018.10–2019.02
RM3620E _59 Vehicle Exterior _076278 HORN _0371457 HORN A

HORN  HORN  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the horn assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)
Front television camera view adjustment Panoramic view monitor system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY (w/ NO. 1 Radiator to Support Seal)

HINT:
B525410C01
1.667,1.333 1.667,1.167 false 1.604,1.333 1.802,1.521 0.198,0.188 10 true *1
*1 No. 1 Radiator To Support Seal


For vehicles with the No. 1 radiator to support seal installed, remove the front bumper assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>REMOVAL


Hide 86510 2.REMOVE HIGH PITCHED HORN ASSEMBLY (w/ NO. 1 Radiator to Support Seal)

a.
B515709C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Disconnect the connector to remove the high pitched horn assembly.


Hide 86520 3.REMOVE LOW PITCHED HORN ASSEMBLY (w/ NO. 1 Radiator to Support Seal)

a.
B515710C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Disconnect the connector to remove the low pitched horn assembly.


Hide 17750A 4.REMOVE INLET AIR CLEANER ASSEMBLY (for Gasoline Model, w/o NO. 1 Radiator to Support Seal)

Hide 53510 5.REMOVE HOOD LOCK ASSEMBLY (w/o NO. 1 Radiator to Support Seal)

Hide 16681A 6.REMOVE RADIATOR UPPER AIR GUIDE PLATE (w/o NO. 1 Radiator to Support Seal)

Hide 86510 7.REMOVE HIGH PITCHED HORN ASSEMBLY (w/o NO. 1 Radiator to Support Seal)

a.
B515635C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Disconnect the connector to remove the high pitched horn assembly.


Hide 86520 8.REMOVE LOW PITCHED HORN ASSEMBLY (w/o NO. 1 Radiator to Support Seal)

a.
B515637C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Disconnect the connector to remove the low pitched horn assembly.