G92Z0
1.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Install the HV battery junction block assembly to the HV battery with the 4 nuts.
If the HV battery junction block assembly has been struck or dropped, replace it with a new one.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Engage the 2 claws to install the wiring harness protector.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Engage the 2 claws to close the wiring harness protector.
Engage the clamp.
Connect the HV battery junction block assembly connector.
Make sure that the connectors are connected securely.
Connect the electric vehicle battery plug assembly with the bolt.
G920NB
2.INSTALL UPPER HV BATTERY COVER SUB-ASSEMBLY
G92F1
3.INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT
82161
4.CONNECT FLOOR WIRE
Be sure to wear insulated gloves.
Engage the 2 clamps to connect the floor wire.
Connect the HV battery junction block assembly connector.
Connect the electric vehicle battery plug assembly connector.
Engage the clamp.
821H1
5.CONNECT HV FLOOR UNDER WIRE
G92N4A
6.INSTALL NO. 1 HV BATTERY COVER PANEL RH
71033
7.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
58464D
8.INSTALL BATTERY SERVICE COVER BOARD
58466J
9.INSTALL NO. 2 BATTERY SERVICE COVER BOARD
67918E
10.INSTALL REAR DOOR SCUFF PLATE LH
58467H
11.INSTALL NO. 3 BATTERY SERVICE COVER BOARD
67917C
12.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
899A0
13.INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
72693
14.INSTALL REAR SEAT CUSHION LOCK HOOK
15.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
G3834
16.INSTALL SERVICE PLUG GRIP