The power back door control switch signal is sent to the multiplex network door ECU.
If the power back door does not operate using the power back door control switch, a power back door control switch circuit malfunction is a possible cause.
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for HV Model)>INITIALIZATION
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for HV Model)>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Back Door Open SW | Power back door control switch signal | ON or OFF | ON: Power back door control switch on
OFF: Power back door control switch off |
- |
| Tester Display |
|---|
| Back Door Open SW |
The power back door control switch functions as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the power back door control switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>REMOVAL
Inspect the power back control door switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G11 power back door control switch connector.
Disconnect the G45 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G11-5 (MSW) - G45-4 (PBDS) | Always | Below 1 Ω |
| G11-2 (MSE) - Body ground | Always | Below 1 Ω |
| G11-5 (MSW) or G45-4 (PBDS) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C