Home › Drivetrain › K120F (MULTIDRIVE / CVT) › REVOLUTION SENSOR(NSS SENSOR) › 2018.10–2020.08
RM3620E _52 Drivetrain _076273 K120F MULTIDRIVE / CVT _0371760 REVOLUTION SENSOR(NSS SENSOR) A

K120F MULTIDRIVE / CVT  REVOLUTION SENSOR(NSS SENSOR)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor (NSS) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
TCM If transaxle compensation code read from TCM
·

Transfer transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)
If transaxle compensation code not read from TCM
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn



NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 89535B 1.REMOVE TCM

Hide 89413T 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NSS)

a.
C400613

Disconnect the transmission revolution sensor (NSS) connector.


b.
C400614

Remove the bolt and transmission revolution sensor (NSS) from the transaxle case sub-assembly.


c.
C395501

Remove the O-ring from the transmission revolution sensor (NSS).