The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during TCM removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
53895B
3.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
53896B
4.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
51441
5.REMOVE NO. 1 ENGINE UNDER COVER
51420
6.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
53737D
7.REMOVE FRONT FENDER APRON SEAL LH
89535B
8.REMOVE TCM
Remove the bolt to disconnect the engine wire from the No. 2 transmission control ECU bracket.
|
Remove in this Direction |
Detach the claw, rotate the lever and disconnect the TCM connector.
Remove the 2 bolts and TCM from the continuously variable transaxle assembly.
89539M
9.REMOVE NO. 1 TRANSMISSION CONTROL ECU BRACKET
Remove the 2 screws and No. 1 transmission control ECU bracket from the TCM.
89539N
10.REMOVE NO. 2 TRANSMISSION CONTROL ECU BRACKET
Remove the 2 screws and No. 2 transmission control ECU bracket from the TCM.