The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DRAIN ENGINE COOLANT
28800
2.REMOVE BATTERY
89422A
3.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Remove the clip and engine coolant temperature sensor from the water outlet.
If the engine coolant temperature sensor has been struck or dropped, replace it.