The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
16031
1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
16323
2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
Disconnect the sensor wire connector.
Disconnect the engine water pump assembly (water inlet housing) connector.
Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).
Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.
Remove the gasket from the engine water pump assembly (water inlet housing).