Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
739F0
1.INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH
|
Install in this Direction |
Install the front seat cushion airbag assembly RH with 2 new nuts.
Do not reuse the nut.
Attach the claw to connect the airbag connector.
Attach the 2 wire harness clamps.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY
3.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY
71861
4.INSTALL FRONT SEAT INNER CUSHION SHIELD RH
71811D
5.INSTALL FRONT SEAT CUSHION SHIELD RH
72525A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY
72551B
7.INSTALL RECLINING HINGE COVER RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY
8.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure described for the LH side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
10.INSTALL BATTERY HOLE COVER (for HV Model)
58416K
11.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
58410B
12.INSTALL DECK BOARD ASSEMBLY (for HV Model)
13. PERFORM DIAGNOSTIC SYSTEM CHECK
14.CHECK SRS WARNING LIGHT