When the LH side refreshing seat switch (seat heater switch) is operated, the air conditioning amplifier assembly receives the signal. The air conditioning amplifier assembly receives the signal and operates the LH side front seat heater.
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption Partial Limit on AC/Heater Operation" is displayed on the multi-information display in the combination meter assembly, inspect the auxiliary battery, referring to On-vehicle Inspection for the charging system.
for A25A-FKS: Click herePower Source / Network>A25A-FKS (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION
for M20A-FKS: Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION
for A25A-FXS: Click herePower Source / Network>A25A-FXS (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption Partial Limit On AC/Heater Operation" is not displayed on the multi-information display in the combination meter assembly, check the Data List item "Battery Control Count (Body ECU)".
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
Inspect the fuse related to this system before inspecting the suspected areas below.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Left Seat Heater | LH side front seat heater operation | OFF/ON | - |
| Tester Display |
|---|
| Front Left Seat Heater |
LH side front seat heater operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the refreshing seat switch (seat heater switch) with a new or known good one.
Click hereVehicle Interior>SEAT>SEAT HEATER SWITCH (for Front Seat)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the LH side front seat heater operation.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK
LH side front seat heater operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Seat Heater Control Sub-assembly LH) |
Disconnect the seat heater control sub-assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| T3-1 (B) - Body ground | Ignition switch ON | 11 to 14 V |
| T3-1 (B) - Body ground | Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G48 air conditioning amplifier assembly connector.
Disconnect the T3 seat heater control sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G48-13 (SM1L) - T3-5 (SWL) | Always | Below 1 Ω |
| G48-13 (SM1L) or T3-5 (SWL) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the T17 front seat cushion heater assembly LH connector.
Disconnect the T3 seat heater control sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T17-6 - T3-10 (E) | Always | Below 1 Ω |
| T17-6 or T3-10 (E) - Other terminals and body ground | Always | 10 kΩ or higher |
| T17-1 - T3-7 (HIL) | Always | Below 1 Ω |
| T17-1 or T3-7 (HIL) - Other terminals and body ground | Always | 10 kΩ or higher |
| T17-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front seat cushion heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Power Seat)>REMOVAL
Inspect the front seat cushion heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Manual Seat)>INSPECTION
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Power Seat)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Power Seat)>REMOVAL
Remove the front seatback heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Power Seat)>REMOVAL
Inspect the front seatback heater assembly LH.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Manual Seat)>INSPECTION
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Power Seat)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEATBACK HEATER (for Power Seat)>REMOVAL
Replace the seat heater control sub-assembly LH with a new or known good one.
for Manual Seat: Click hereVehicle Interior>SEAT>SEAT HEATER CONTROL (for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>SEAT HEATER CONTROL (for Power Seat)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the LH side front seat heater operation.
Click hereVehicle Interior>SEAT>SEAT HEATER SYSTEM>OPERATION CHECK
LH side front seat heater operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG