The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.REMOVE FRONT SEAT ASSEMBLY LH
72495
3.REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)
72552B
4.REMOVE RECLINING HINGE COVER LH
72526A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
71849
6.REMOVE SEAT ADJUSTER COVER CAP LH (for Driver Side)
71812D
7.REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)
71811D
8.REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
71862
9.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
71861
10.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
12.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
71074S
13.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
87510N
14.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (for Driver Side)
Remove the 16 tag pins and front seatback heater assembly LH from the separate type front seatback cover.
Be careful not to damage the separate type front seatback cover and front seatback heater assembly LH.
87510M
15.REMOVE FRONT SEATBACK HEATER ASSEMBLY RH (for Front Passenger Side)
for Standard Seat Type:
Remove the 16 tag pins and front seatback heater assembly RH from the separate type front seatback cover.
Be careful not to damage the separate type front seatback cover and front seatback heater assembly RH.
for Sports Seat Type:
Remove the 14 tag pins and front seatback heater assembly RH from the separate type front seatback cover.
Be careful not to damage the separate type front seatback cover and front seatback heater assembly RH.