The headlight ECU sub-assembly LH stores this DTC if the value from the rear height control sensor sub-assembly LH is out of range when performing initialization of the headlight ECU sub-assembly LH, such as when the vehicle is not level or jacked up.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2452 | Abnormal Height Sensor Data at Initialization | Detection condition:
The ignition switch is ON Malfunction status:
Abnormal rear height control sensor sub-assembly LH value detected during initialization Malfunction duration:
- |
·
Vehicle condition when initializing ·
Rear height control sensor sub-assembly LH ·
Harness or connector ·
Headlight ECU sub-assembly LH |
- |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
Perform initialization of the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Clear DTCs.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B2452 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the installation condition of the rear height control sensor sub-assembly LH.
Rear height control sensor sub-assembly LH is installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL
Inspect the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A11 headlight ECU sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O3-3 (SHB) - A11-16 (SBR) | Always | Below 1 Ω |
| O3-2 (SHRR) - A11-17 (SHRL) | Always | Below 1 Ω |
| O3-1 (SHG) - A11-15 (SGR) | Always | Below 1 Ω |
| O3-3 (SHB) or A11-16 (SBR) - Body ground | Always | 10 kΩ or higher |
| O3-2 (SHRR) or A11-17 (SHRL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG