If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
88211B
1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
| *A | except Off Road Package |
| *B | for Off Road Package |
|
Bolt |
|
Screw |
Attach the guide.
Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw.
Tighten the 2 bolts and screw in the order shown in the illustration.
Connect the connector.
16681A
2.INSTALL RADIATOR UPPER AIR GUIDE PLATE (w/o NO. 1 Radiator to Support Seal)
53510
3.INSTALL HOOD LOCK ASSEMBLY (w/o NO. 1 Radiator to Support Seal)
17750A
4.INSTALL INLET AIR CLEANER ASSEMBLY (for Gasoline Model, w/o NO. 1 Radiator to Support Seal)
5.INSTALL FRONT BUMPER ASSEMBLY (w/ NO. 1 Radiator to Support Seal)
53301
6.INSPECT HOOD SUB-ASSEMBLY (w/o NO. 1 Radiator to Support Seal)
86790B
7.ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ NO. 1 Radiator to Support Seal, w/ Panoramic View Monitor System)
for Gasoline model:
8.PERFORM CALIBRATION (w/ NO. 1 Radiator to Support Seal, w/ Parking Support Brake System)
w/ Parking Support Brake System(for HV Model):
w/ Parking Support Brake System(for Gasoline Model):
9.ADJUST MILLIMETER WAVE RADAR SENSOR
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT