Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0379312 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster)  Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)  


DESCRIPTION

Depending on the malfunction, the skid control ECU (brake booster with master cylinder assembly) prohibits operation of the electronically controlled brake system to protect components and prevent incorrect operation when DTCs are stored.

If the switching solenoid is disabled due to prohibition of the electronically controlled brake system, the response of the brake pedal changes and braking performance is reduced.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>UTILITY


PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check the conditions at the time the problem occurred.

i.

Whether a warning light illuminated or the buzzer sounded.


ii.

Road surface condition when the problem occurred and just before the problem occurred.


iii.

When the problem occurred and how many times the brake pedal was depressed before the problem occurred.


iv.

Frequency of the abnormal brake pedal response.



Result:
Proceed to
NEXT



NEXT

2.CHECK BRAKE PEDAL
2.CHECK BRAKE PEDAL
a.

While depressing the brake pedal by hand, check the installation condition of the brake pedal stroke sensor assembly and brake pedal, and check for mechanical malfunctions.



Result:
Proceed to
NEXT



NEXT

3.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
3.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
a.

Check the brake booster with master cylinder assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE SYSTEM (w/o Vacuum Brake Booster)>ON-VEHICLE INSPECTION

OK:

The brake booster with master cylinder assembly is normal.



Result:
Proceed to
OK
NG



OK

NG