The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear traction motor with transaxle assembly removal/installation are shown below.
This vehicle has contains high voltage circuits standardized with orange colored wiring and connectors, so follow the instructions in this manual to perform the procedures correctly.
If the correct procedures are not followed according to the instructions in this manual, there is a danger of electric shock from the high voltage circuits.
Be sure to wear insulating gloves when working on high voltage wiring or components.
If work is performed without wearing insulating gloves, there is a danger of electric shock.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
58410B
1.REMOVE DECK BOARD ASSEMBLY
58416K
2.REMOVE REAR NO. 2 FLOOR BOARD
65351A
3.REMOVE BATTERY HOLE COVER
4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
58441J
5.REMOVE BATTERY SERVICE HOLE COVER
6.REMOVE SERVICE PLUG GRIP
7.REMOVE NO. 2 INVERTER PROTECTOR (w/ No. 2 Inverter Protector)
82111
8.DISCONNECT ENGINE ROOM MAIN WIRE
9.REMOVE CONNECTOR COVER ASSEMBLY
10.CHECK TERMINAL VOLTAGE
11.INSTALL CONNECTOR COVER ASSEMBLY
82111
12.CONNECT ENGINE ROOM MAIN WIRE
13.INSTALL NO. 2 INVERTER PROTECTOR (w/ No. 2 Inverter Protector)
14.DRAIN HYBRID TRANSAXLE FLUID
15.REMOVE REAR DRIVE SHAFT ASSEMBLY
51206A
16.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
17.DISCONNECT WIRE HARNESS
| *a | Temperature Sensor Connector |
| *b | Resolver Sensor Connector |
Disconnect the temperature sensor connector.
Disconnect the resolver sensor connector.
Detach the 4 clamps to disconnect the wire harness from the rear traction motor with transaxle assembly and rear suspension member sub-assembly.
G1050
18.REMOVE REAR TRACTION MOTOR WITH TRANSAXLE ASSEMBLY
Using an engine sling device and chain block, hold the rear traction motor with transaxle assembly.
Do not lift the rear traction motor with transaxle assembly more than necessary.
Check the center of gravity while lifting the rear traction motor with transaxle assembly.
Lightly shake the rear traction motor with transaxle assembly by hand to make sure it is securely held while performing work.
Do not shake the rear traction motor with transaxle assembly excessively while holding it.
| *1 | Upper Differential Mount Stopper |
| *2 | Lower Differential Mount Stopper |
Remove the 3 bolts, 2 upper differential mount stoppers, 2 lower differential mount stoppers and rear traction motor with transaxle assembly from the rear suspension member sub-assembly.
Do not drop the rear traction motor with transaxle assembly.
Do not damage the installation surface of the rear traction motor with transaxle assembly.
19.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the 4 bolts and 3 wire harness clamp brackets from the rear traction motor with transaxle assembly.
52380F
20.REMOVE FRONT DIFFERENTIAL SUPPORT ASSEMBLY
Remove the 2 bolts and front differential support assembly from the rear traction motor with transaxle assembly.
G1050C
21.REMOVE REAR TRACTION MOTOR FILLER PLUG
There is no need to remove this unless the rear traction motor filler plug is replaced.
Using a 10 mm hexagon socket wrench, remove the rear traction motor filler plug and gasket from the rear traction motor with transaxle assembly.