Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD without Vacuum Brake Booster) › 2019.02–2020.08
RM3620E _54 Brake _076411 BRAKE SYSTEM (OTHER) _0377034 BRAKE PEDAL(for LHD without Vacuum Brake Booster) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD without Vacuum Brake Booster)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)
Replacement of brake pedal support assembly
·

Clear the zero point calibration data and stored linear solenoid valve calibration data

·

Perform initialization and calibration of the linear solenoid valve

·

Perform yaw rate and acceleration sensor zero point calibration


·

DTCs are stored

·

ABS warning light illuminates

·

Brake warning light / yellow (minor malfunction) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.


Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 87211A 3.REMOVE NO. 2 AIR DUCT

Hide 84340 5.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 6.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47110 7.DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY

a.
C406493

Disengage the 2 clamps.


b.
C406495

Remove the bolt and disconnect the brake pedal support assembly from the instrument panel reinforcement assembly.


Hide 47101A 8.REMOVE BRAKE PEDAL RETURN SPRING

a.
C406497

Remove the brake pedal return spring from the brake pedal support assembly.


Hide 47264A 9.REMOVE PUSH ROD PIN

a.
C406499

Remove the clip and push rod pin.


Hide 10.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY

Hide 11.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C406501

w/ clip:

i.

Remove the 2 clips from the brake pedal support assembly.



b.
C406503

Remove the 4 nuts and brake pedal support assembly.


Hide 47121 12.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.