Home › Engine / Hybrid System › A25A-FKS (STARTING) › STARTER (for 1.2 kW Type) › 2019.09–2020.08
RM3620E _51 Engine / Hybrid System _076487 A25A-FKS STARTING _0409133 STARTER(for 1.2 kW Type) A

A25A-FKS STARTING  STARTER(for 1.2 kW Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 11363A 7.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A402142

Detach the claw as shown in the illustration to remove the flywheel housing side cover.


Hide 28100 8.REMOVE STARTER ASSEMBLY

a.
A434683

Remove the bolt and disconnect the engine wire from the vehicle body.


b.
A402139

Detach the clamp to disconnect the radiator hose from the fan shroud assembly.


c.

Detach the 2 clamps to disconnect the engine wire and No. 2 engine wire from the automatic transaxle assembly.


d.
A402140

Detach the 3 clamps to disconnect the radiator hose, vacuum hoses and No. 2 engine wire from the No. 1 radiator bracket.


e.
A402141

Remove the bolt and No. 1 radiator bracket from the front engine mounting.


f.
A402144

Disconnect the starter assembly connector.


g.

Open the terminal cap.


h.
A402145

Remove the nut and disconnect the No. 2 engine wire from terminal 30.


i.
A402146

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.