The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear transfer case oil seal removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
| *a | An Object Exceeding Weight Limit of Transmission Jack |
The automatic transaxle assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop.
1.REMOVE TRANSFER ASSEMBLY
36100A
2.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
36100
3.SECURE TRANSFER ASSEMBLY
4.INSPECT TOTAL PRELOAD
5.REMOVE OUTPUT SHAFT COMPANION FLANGE NUT
33309B
6.REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
36111X
7.REMOVE NO. 2 TRANSFER CASE OIL SEAL
| *1 | No. 2 Transfer Case Oil Seal |
Using SST, remove the No. 2 transfer case oil seal from the transfer case.
Do not damage the No. 2 transfer case oil seal press-fit surface.
Remove the spacer.
| *1 | Rear Drive Pinion Bearing (Inner Race) |
Using SST, remove the rear drive pinion bearing (inner race).
Remove the transfer pinion bearing spacer.
Using SST, remove the rear drive pinion bearing (outer race).
| *1 | Rear Drive Pinion Bearing (Outer Race) | - | - |
| *a | Turn | *b | Hold |
36111X
8.INSTALL NO. 2 TRANSFER CASE OIL SEAL
| *1 | Rear Drive Pinion Bearing (Outer Race) |
Using SST and a press, install the rear drive pinion bearing (outer race).
Install a new transfer pinion bearing spacer.
Temporarily install the output shaft companion flange.
| *a | Turn |
| *b | Hold |
Using SST, install the rear drive pinion bearing (inner race).
| *a | Turn |
| *b | Hold |
Using SST, remove the output shaft companion flange.
install the spacer.
Apply a small amount of MP grease to the lip of a new No.2 transfer case oil seal.
| *1 | No. 2 Transfer Case Oil Seal |
Using SST, install a new No. 2 transfer case oil seal to the transfer case.
3.9 to 4.9 mm (0.154 to 0.193 in.)
Do not damage the No. 2 transfer case oil seal press-fit surface.
Press using the A surface.
33309B
9.INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
10.INSPECT TOTAL PRELOAD
11.INSTALL OUTPUT SHAFT COMPANION FLANGE NUT
36100
12.REMOVE TRANSFER ASSEMBLY
36100A
13.INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT
14.INSTALL TRANSFER ASSEMBLY