Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › from 2020.08
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0372098 TELEMATICS SYSTEM(for eCall) T

TELEMATICS  TELEMATICS SYSTEM(for eCall)  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Manual (SOS) Switch Indicator Display Problem
Symptom Suspected Area Link
The manual (SOS) switch illumination does not illuminate Proceed to "Emergency Call Switch Illumination Circuit" Click here
The manual (SOS) switch indicator (red) illuminates after the ignition switch is turned to ON Proceed to "DTC CHECK/CLEAR" Click here
Proceed to "VEHICLE CONTROL HISTORY" Click here

Warning Notification Function
Symptom Suspected Area Link
The multi-display screen does not show a warning message even though a warning light turns on or the multi-information display indicates a warning. Proceed to "Warning Notification Function Malfunction" Click here
The multi-display screen shows a warning message even though no warning lights are on and the multi-information display does not indicate a warning. Proceed to "Warning Notification Function Malfunction" Click here
The multi-display screen shows a warning message different from the warning light or the multi-information display. Proceed to "Warning Notification Function Malfunction" Click here

Alarm Notification Function
Symptom Suspected Area Link
When the theft deterrent system is activated, the service center is not informed of the alarm Proceed to "Alarm Notification Function Malfunction" Click here

Remote Service Function
Symptom Suspected Area Link
The specific remote service cannot be used After connecting the GTS, communication function pausing mode may be set. Cancel communication function pausing mode using the GTS. (w/o Radio and Display Receiver) Click here
Use the GTS to check whether the service subscription is active. Click here
Check that the meter / gauge system is operating normally Click here
Check that the entry and start system (for Entry Function) is operating normally (for HV Model) Click here
Check that the entry and start system (for Entry Function) is operating normally (for Gasoline Model) Click here
Check that the theft deterrent system is operating normally Click here
Check that the lighting system (EXT) is operating normally Click here
Check that the lighting system (INT) is operating normally Click here
Check that the power door lock control system is operating normally Click here
Proceed to "DCM Operation History" in Utility Click here
Contact service center -