Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER (for Manual Seat) › from 2020.08
RM3620E _58 Vehicle Interior _076405 SEAT _0377516 FRONT SEAT CUSHION HEATER(for Manual Seat) A

SEAT  FRONT SEAT CUSHION HEATER(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat cushion heater assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative (-) battery terminal Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)
Front passenger seat Zero point calibration (Occupant classification system)
·

Occupant classification system (for HV model)

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system for A25A-FKS:(Click here)
for M20A-FKS:(Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
Front passenger seat Zero point calibration (Occupant Classification System)
·

Occupant classification system (for Gasoline model)

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


CAUTION:
·
B521791

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·
B458500

Be sure to read precaution thoroughly before servicing.


·
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If an SRS part is accidentally deployed, it may cause a serious injury.



NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)

Hide 72552B 4.REMOVE RECLINING HINGE COVER LH

Hide 72526A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

Hide 71849 6.REMOVE SEAT ADJUSTER COVER CAP LH (for Driver Side)

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)

Hide 71811D 8.REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)

Hide 71862 9.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)

Hide 71861 10.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)

Hide 11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 12.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Hide 71072S 13.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

Hide 87510L 14.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (for Driver Side)

a.
B521469

Remove the 14 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.

NOTICE:

Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH.



Hide 87510K 15.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH (for Front Passenger Side)

a.

for Standard Seat Type:

i.
B529826

w/o Climate Control Seat System:

Remove the 14 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover.

NOTICE:

Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH.



ii.
B531887

w/ Climate Control Seat System:

Remove the 19 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover.

NOTICE:

Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH.




b.

for Sports Seat Type:

i.
B532226

w/o Climate Control Seat System:

Remove the 12 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover.

NOTICE:

Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH.



ii.
B531888

w/ Climate Control Seat System:

Remove the 19 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover.

NOTICE:

Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly RH.