The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the compressor with motor assembly removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD with NICKEL METAL HYDRIDE BATTERY)>PRECAUTION
for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD with NICKEL METAL HYDRIDE BATTERY)>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
G3834
2.REMOVE SERVICE PLUG GRIP
3.CHECK TERMINAL VOLTAGE
Disconnect the engine room main wire.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>FRAME WIRE>REMOVAL
Remove the connector cover assembly.
Check the terminal voltage.
Install the connector cover assembly.
Connect the engine room main wire.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>FRAME WIRE>INSTALLATION
4.REMOVE FRONT WHEEL RH
75601A
5.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure described as for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>WHEEL OPENING MOULDING (for Front)>REMOVAL
53896B
6.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
53895B
7.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
51441
8.REMOVE NO. 1 ENGINE UNDER COVER
76621D
9.REMOVE FRONT FENDER MUDGUARD RH (w/ Mudguard)
Use the same procedure described as for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>MUDGUARD>REMOVAL
53736E
10.REMOVE FRONT FENDER APRON SEAL RH
53875A
11.REMOVE FRONT FENDER LINER RH
88704
12.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
88711
13.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
88370
14.REMOVE COMPRESSOR WITH MOTOR ASSEMBLY