Home › Drivetrain › EG62 (MANUAL TRANSMISSION / TRANSAXLE) › NEUTRAL POSITION SWITCH › from 2020.08
RM3620E _52 Drivetrain _076270 EG62 MANUAL TRANSMISSION / TRANSAXLE _0371320 NEUTRAL POSITION SWITCH A

EG62 MANUAL TRANSMISSION / TRANSAXLE  NEUTRAL POSITION SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the neutral position switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 28800 3.REMOVE BATTERY

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 74404B 8.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 84545 9.REMOVE NEUTRAL POSITION SWITCH

a.
C405636

Disconnect the neutral position switch connector.


b.
C405637N01
2.646,0.948 2.833,1.125 2.833,1.125 2.958,1.125 true 3,1.031 3.365,1.26 0.365,0.229 10 false SST

Using SST, remove the neutral position switch and gasket from the manual transmission case.

SST
09816-30010