Home › Engine / Hybrid System › M20A-FKS (STARTING) › STARTER (for 1.2 kW Type) › from 2020.08
RM3620E _51 Engine / Hybrid System _076488 M20A-FKS STARTING _0372206 STARTER(for 1.2 kW Type) A

M20A-FKS STARTING  STARTER(for 1.2 kW Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 11363A 7.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A434685

Detach the claw as shown in the illustration to remove the flywheel housing side cover.


Hide 28100 8.REMOVE STARTER ASSEMBLY

a.
A434689C01
0.063,0.031 0.292,0.24 0.229,0.208 10 true *A 0.094,2.521 0.323,2.75 0.229,0.229 10 true *B
*A for CVT
*B for Manual Transaxle


Detach the clamp, remove the bolt and disconnect the engine wire.


b.
A434686

Disconnect the starter assembly connector.


c.

Open the terminal cap.


d.
A434687

Remove the nut and disconnect the engine wire from terminal 30.


e.
A434688

Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.