The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
1.DRAIN ENGINE COOLANT
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Grille Shutter)
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY (w/ Grille Shutter)
4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (w/ Grille Shutter)
89422N
5.REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Grille Shutter)
Disconnect the No. 2 engine coolant temperature sensor connector.
Remove the clip and No. 2 engine coolant temperature sensor from the water outlet.
If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
G9200
6.REMOVE INVERTER WITH CONVERTER ASSEMBLY
89422A
7.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Remove the clip and engine coolant temperature sensor from the water outlet.
If the engine coolant temperature sensor has been struck or dropped, replace it.