Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM (w/ Memory)

POWER MIRROR CONTROL SYSTEM (w/ Memory) > Power Mirror Surface Position is not Memorized

for Preparation Click here


SYSTEM DESCRIPTION

The outer rear view mirror assembly has a mirror position sensor. The front power seat switch LH sends instructions to the outer mirror control ECU. Then the outer mirror control ECU receives mirror information from the mirror position sensors, and memorizes the mirror positions.

INSPECTION PROCEDURE

1.CHECK DTC
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).
    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK SEAT MEMORY SWITCH FUNCTION (SEAT POSITION MEMORY FUNCTION)
  1. Check that the driver side seat can be moved using the seat memory switch.

    OK:
    Driver side seat can be moved using seat memory switch.



NG
GO TO FRONT POWER SEAT CONTROL SYSTEM (POWER SEAT POSITION IS NOT MEMORY) (Click here)
OK


3.CHECK SEAT MEMORY SWITCH FUNCTION (REGISTRATION OF SEAT MEMORY SWITCH)
  1. Check that the memory operation is properly completed.

    NOTICE:
    1. The seat position will not be recorded if the seat memory SET switch and 2 or more of the seat memory switches (for example, seat memory switch 1 and seat memory switch 2) are pressed simultaneously.
    2. If the operation fails, the mirror facing direction will not be memorized until the seat memory SET switch is turned off.
    3. The mirror facing direction will not be memorized when the mirror is operated manually.

    OK:
    Driver side seat position can be memorized using seat memory switch (for Driver Side).



NG
Go to step 4
OK

END 

4.READ VALUE USING TECHSTREAM (MIRROR POSITION MEMORY)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream ON.

  1. Enter the following menus: Body Electrical / Mirror / Data List.

  1. According to the display on the Techstream, read the Data List.

    Mirror 
    Tester Display
    Measurement Item/Display
    Normal Condition
    Diagnostic Note
    Mirror Memory No. 1
    Mirror position memorized in seat memory switch memory M1 / ON or OFF
    ON: Memorized
    OFF: Not memorized
    -
    Mirror Memory No. 2
    Mirror position memorized in seat memory switch memory M2 / ON or OFF
    ON: Memorized
    OFF: Not memorized
    -

    OK:
    On the Techstream screen, each item changes between ON and OFF according to above chart.



NG
REPLACE OUTER MIRROR CONTROL ECU (Click here)
OK

REPLACE FRONT POWER SEAT SWITCH LH (Click here)