Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH


C180767
  1. Temporarily install the upper side of the shock absorber to the chassis frame with the bolt and nut.

  1. Temporarily install the lower side of the shock absorber to the lower suspension arm with the bolt.



    C180604
  1. Connect the AVS connector (w/ AVS).



2. INSTALL REAR STABILIZER BAR
(Click here)


3. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


C180589
  1. Install the rear height control sensor with the nut.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the rear height control sensor connector.



    C180588
  1. Align the matchmark on the rear height control sensor link and bracket.

  1. Install the rear height control sensor link with the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


5. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD)
(Click here)


6. INSTALL TAILPIPE ASSEMBLY
  1. Connect the tailpipe assembly to the 2 exhaust pipe supports.



    A207210E01
  1. Install a new gasket to the center exhaust pipe assembly.

  1. Connect the tailpipe to the center exhaust pipe assembly.

  1. Attach a new clamp to the tailpipe assembly and center exhaust pipe assembly. Then install the bolt to the clamp.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

    HINT:
    Install the clamp so that it is positioned as shown in the illustration.



7. INSTALL REAR WHEEL

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }



8. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



9. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH


C180767E01
  1. Tighten the 2 bolts and nut.

    Torque:
    for bolt and nut A:
    135 N*m{ 1377 kgf*cm , 100 ft.*lbf }
    for bolt B:
    90 N*m{ 918 kgf*cm , 67 ft.*lbf }



10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)