Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

When the cruise control main switch is on, the CRUISE main indicator light and READY indicator light come on. This indicates the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state through the multiplex communication system. The master warning light and CRUISE main indicator light come on and vehicle-to-vehicle distance information is displayed on the combination meter as the alarm buzzer sounds.

HINT:

If the vehicle in front in the same lane significantly decreases vehicle speed or another vehicle cuts in front of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance will shorten. At this time, the system sounds the buzzer and the multi-information display blinks to warn the driver.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the CRUISE main indicator light by performing the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Cruise "CRUISE" indicator light BLINK/OFF -



OK

2.READ VALUE USING TECHSTREAM

NG

REPLACE COMBINATION METER ASSEMBLY

2.READ VALUE USING TECHSTREAM
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Powertrain / Laser Cruise / Data List.


e.

Check the Data List for proper functioning of the CRUISE main indicator light.

ECM (Laser Cruise)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Ready M-CPU Cruise control system standby condition (Main CPU) / ON or OFF Each time main switch is pushed, ON/OFF changes "1"
CCS Indicator M-CPU Cruise indicator signal (Main CPU) / ON or OFF ON: "CRUISE" on
OFF: "CRUISE" off
"2"

OK:

When the cruise control main switch is operated, the display changes as shown above.


Result
Result Proceed to
OK A
NG (for 3UR-FE) B
NG (for 3UR-FBE) C

HINT:

"1" is OK, but "2" is NG → DTC output or ECM failure




A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

B

C