Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM
RM27L0U _51 Engine / Hybrid System _049309 CRUISE CONTROL _0235640 DYNAMIC LASER CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC LASER CRUISE CONTROL SYSTEM  P1630  Communication Error from VSC to ECM  


DESCRIPTION

The skid control ECU sends signals such as cruise control cancel demand signals and brake operation demand (from ECM) response signals to the ECM when the dynamic laser cruise control system is in operation.

DTC No. DTC Detection Condition Trouble Area
P1630 While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is logically inconsistent for 0.5 seconds, the ECM records this logical error code
·

Communication circuit

·

Skid control ECU

·

ECM



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


NOTICE:

When the distance control ECU and ECM is replaced with a new one, initialization must be performed (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.REPLACE SKID CONTROL ECU

NEXT

2.CLEAR DTC
2.CLEAR DTC

NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Reproduce the DTC detection conditions under which the DTC is stored.

HINT:

If the DTC detection conditions are not correct, the system will not detect the trouble.



b.

Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.


c.

Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for 3UR-FE) B
DTC is output (for 3UR-FBE) C



A

END

B

C