The skid control ECU receive signals from the active brake booster's internal micro switch to detect if the brake pedal is depressed.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1267 | During cruise control operation a micro switch error is stored under the following conditions: A micro switch error flag remains ON for 0.5 seconds or more, the micro switch condition does not match the signal sent from the VSC system, or the micro switch and oil pressure sensor values do not match for 1 second or more. | ·
Active brake booster (micro switch) ·
ECM ·
VSC system ·
Wire harness or connector |
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.
Check the DTC for Vehicle Stability Control System (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Disconnect the A27 connector from the ECM.
Disconnect the A19 connector from the ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A19-40 (PSOO) - A27-36 (STV) | Always | Below 1 Ω |
| A19-40 (PSOO) or A27-36 (STV) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM and ECU connector.
OK
NG
Temporarily replace the VSC actuator assembly with a new or normally functioning one (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL).
NEXT
Clear the DTC (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTC (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
C1267 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 3UR-FE) | B |
| NG (for 3UR-FBE) | C |
A
B
C