Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM27L0U _53 Suspension _049318 REAR SUSPENSION _0235726 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48815R 1.INSTALL REAR STABILIZER BUSH

a.

Install the 2 bushes to the outer side of the bush stoppers on the rear stabilizer bar.

HINT:

Install the bush so that the cutout faces the rear of the vehicle.



Hide 48812 2.TEMPORARILY INSTALL REAR STABILIZER BAR

a.

Temporarily install the rear stabilizer bar with the 4 bolts.


Hide 48824R 3.TIGHTEN REAR STABILIZER BRACKET

C180768E02
0.094,0.094 0.698,0.385 0.604,0.292 10 true LH Side: 0.104,2.406 0.708,2.698 0.604,0.292 10 true RH Side:

a.

Install the rear stabilizer bar with the 4 bolts.

Torque:
27 N*m (275 kgf*cm, 20 ft.*lbf)


Hide 48840A 4.TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY LH

C180603

a.

Temporarily install the rear stabilizer link with the 2 nuts.


Hide 48830D 5.TEMPORARILY INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 37110 6.INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD)

Hide 37117 9.REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)

Hide 17430 10.INSTALL EXHAUST PIPE ASSEMBLY TAIL (for 3UR-FE)

Hide 17430 11.INSTALL EXHAUST PIPE ASSEMBLY TAIL (for 3UR-FBE)

Hide 48840A 13.TIGHTEN REAR STABILIZER LINK ASSEMBLY LH

a.

Install the rear stabilizer link with the 2 nuts.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 48830D 14.TIGHTEN REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.