Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU
RM27L0U _55 Steering _049326 POWER ASSIST SYSTEMS _0235760 POWER STEERING ECU A

POWER ASSIST SYSTEMS  POWER STEERING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

Some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 53601 6.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55046A 7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 55410C 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 89650 10.REMOVE POWER STEERING ECU ASSEMBLY

a.
C181335

Disconnect the power steering ECU connector.


b.

Remove the nut and power steering ECU assembly.