Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
RM27L0U _55 Steering _049327 STEERING COLUMN _0235762 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2621  Communication Interruption  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that they are connected to the network by outputting a specified signal (periodical signal) to the communication bus at regular intervals. The multiplex tilt and telescopic ECU detects the connection of each ECU based on the signal.

DTC Code Detection Condition Trouble Area
B2621 Periodical signal from the specified ECU has stopped.
·

CAN communication system

·

Main body ECU

·

Front power seat control switch LH

·

Combination meter

·

Multiplex tilt and telescopic ECU



PROCEDURE

1.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Check the DTC of the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

2.READ VALUE USING TECHSTREAM (MAIN BODY ECU COMMUNICATION SIGNAL)

B

2.READ VALUE USING TECHSTREAM (MAIN BODY ECU COMMUNICATION SIGNAL)
a.

Use the Data List to check if the main body ECU communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
J/B Communication state of main body ECU signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-


OK:

"OK" is displayed.



OK

3.READ VALUE USING TECHSTREAM (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL)

NG

REPLACE MAIN BODY ECU

3.READ VALUE USING TECHSTREAM (FRONT POWER SEAT CONTROL ECU AND SWITCH LH COMMUNICATION SIGNAL)
a.

Use the Data List to check if the front power seat control ECU and switch LH communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Receive from Seat ECU Communication state of front power seat control switch LH signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-


OK:

"OK" is displayed.



OK

4.READ VALUE USING TECHSTREAM (COMBINATION METER ECU COMMUNICATION SIGNAL)

NG

REPLACE FRONT POWER SEAT SWITCH LH (DRIVER SEAT ECU)

4.READ VALUE USING TECHSTREAM (COMBINATION METER ECU COMMUNICATION SIGNAL)
a.

Use the Data List to check if the combination meter ECU communication signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Receive from Meter Communication state of combination meter signal / OK or Interpt OK: Communication is normal
Interpt: Communication is interrupted
-


OK:

"OK" is displayed.



OK

NG

REPLACE COMBINATION METER ASSEMBLY (COMBINATION METER ECU)