Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
4.REMOVE LOWER NO. 3 STEERING WHEEL COVER
45186
5.REMOVE LOWER NO. 2 STEERING WHEEL COVER
45130
6.REMOVE STEERING PAD
45100
7.REMOVE STEERING WHEEL ASSEMBLY
45287
8.REMOVE LOWER STEERING COLUMN COVER
Remove the 2 screws.
Detach the 2 claws to remove the lower steering column cover.
45286B
9.REMOVE UPPER STEERING COLUMN COVER
Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
10.REMOVE COMBINATION SWITCH WITH SPIRAL CABLE
Disconnect the all connectors from the combination switch with spiral cable.
Using pliers, grip the claws of the clamp and remove the combination switch with spiral cable from the steering column.
67914
11.REMOVE FRONT DOOR SCUFF PLATE LH
62112
12.REMOVE COWL SIDE TRIM BOARD LH
55318C
13.REMOVE INSTRUMENT SIDE PANEL LH
53601
14.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55046A
15.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
73900
16.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
87201F
17.REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY
Remove the bolt and air duct.
45220
18.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY
Remove the 3 bolts and nut.
Put matchmarks on the steering intermediate shaft and the steering column.
| *a | Matchmark |
Remove the bolt and steering intermediate shaft from the steering column.
Put matchmarks on the No. 2 steering intermediate shaft and steering intermediate shaft.
| *a | Matchmark |
Remove the bolt.
Disconnect the steering intermediate shaft from the No. 2 steering intermediate shaft.
45203
19.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Put matchmarks on the No. 2 steering intermediate shaft and power steering gear.
| *a | Matchmark |
Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.
45250
20.REMOVE STEERING COLUMN ASSEMBLY
Disconnect the connectors and disengage the wire harness clamps from the steering column assembly.
Remove the bolt and 2 nuts. Then remove the steering column from the instrument panel reinforcement.